User manual

Remote Control
R&S
®
RTO
707User Manual 1316.0827.02 ─ 06
Parameters:
<Endianness> BENDian | LENDian
BENDian
Big endian, data is analyzed and evaluated in the order of recep-
tion.
LENDian
Little endian, the instrument reads the complete data and then
compares it with the data pattern in reverse order.
*RST: BENDian
TRIGger<m>:LIN:DLECondition <DLCOperator>
Operator to set the data length code for triggering on LIN data. For big endian transfer
direction, you can trigger on a number of bytes less than the data length of the frame,
that means, on the beginning of the data pattern. For little endian transfer direction, the
exact number of data bytes in the frame must be set. The number of data bytes to be
found is set with TRIGger<m>:LIN:DLENgth on page 707.
Example: Data length ≥ 2 and Transfer = Big endian. The frame has at least two bytes,
and you trigger on the data of the first two bytes.
See also:TRIGger<m>:LIN:BORDer on page 706 .
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<DLCOperator> EQUal | GETHan
For little endian transfer direction, EQUal must be set.
*RST: GETHan
TRIGger<m>:LIN:DLENgth <WordCount>
Sets the length of the bit pattern to be found, in bytes. For "Big Endian" transfer direction,
you can trigger on a number of bytes less than the data length of the frame, that means,
on the beginning of the data pattern. For "Little Endian" transfer direction, the exact num-
ber of data bytes in the frame must be set.
For complete definition, set also the operator with TRIGger<m>:LIN:DLECondition
on page 707.
Suffix:
<m>
.
1..3
<m> 1..3
Event in a trigger sequence: 1 = A-event only
Command Reference