User manual

Remote Control
R&S
®
RTO
704User Manual 1316.0827.02 ─ 06
Parameters:
<Type> SYNC | ID | IDOR | IDDT | WKFR | ERRC
SYNC
Start of the frame, triggers on the stop bit of the sync field.
ID
Sets the trigger to one specific identifier or an identifier range.
To set the identifier, use TRIGger<m>:LIN:ICONdition, 
TRIGger<m>:LIN:IMIN on page 705, and TRIGger<m>:
LIN:IMAX on page 705.
IDOR
Triggers on an OR combination with up to four four identifier con-
ditions. For each identifier condition, enable it with 
TRIGger<m>:LIN:IDOR<n>:ENABle and set the value with 
TRIGger<m>:LIN:IDOR<n>[:VALue]
IDDT
Combination of identifier and data conditions
To set the identifier condition, use TRIGger<m>:LIN:
ICONdition, TRIGger<m>:LIN:IMIN, and TRIGger<m>:
LIN:IMAX.
To set the data condition, use TRIGger<m>:LIN:DCONdition,
TRIGger<m>:LIN:DMIN, and TRIGger<m>:LIN:DMAX.
WKFR
Wakeup frame
ERRC
Error condition. Define the error types with TRIGger<m>:LIN:
CHKSerror on page 709, TRIGger<m>:LIN:IPERror, and 
TRIGger<m>:LIN:SYERror
*RST:
SYNC
TRIGger<m>:LIN:ICONdition <IdentifierOperator>
Sets the operator to set a specific identifier or an identifier range.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Command Reference