User manual

Remote Control
R&S
®
RTO
701User Manual 1316.0827.02 ─ 06
16.2.14.6
LIN (Option R&S RTO-K3)
● LIN Configuration..................................................................................................701
● LIN Trigger............................................................................................................703
● LIN Decoding Results...........................................................................................710
● Translation............................................................................................................716
LIN Configuration
BUS<m>:LIN:DATA:SOURce..........................................................................................701
BUS<m>:LIN:DATA:THReshold.......................................................................................701
BUS<m>:LIN:TECHnology..............................................................................................702
BUS<m>:LIN:BITRate....................................................................................................702
BUS<m>:LIN:POLarity....................................................................................................702
BUS<m>:LIN:STANdard.................................................................................................703
BUS<m>:LIN:DATA:SOURce <DataSource>
Sets the waveform of the data line.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<LINSettingsDataSrc>NONE | C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | R1 |
R2 | R3 | R4
See chapter 16.2.2.2, "Waveform Parameter", on page 419
*RST: NONE
Usage: Asynchronous command
BUS<m>:LIN:DATA:THReshold <Threshold>
Sets a user-defined threshold value.
Alternatively, you can set the threshold according to the signal technology with 
BUS<m>:LIN:TECHnology.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<Threshold> Range: -12 to 12
Increment: 0.1
*RST: 0
Default unit: V
Command Reference