User manual

Remote Control
R&S
®
RTO
691User Manual 1316.0827.02 ─ 06
Parameters:
<DataOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan | INRange |
OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with TRIGger<m>:CAN:DMIN.
INRange | OORange
In range / Out of range: Set the minimum and maximum value of
the range with TRIGger<m>:CAN:DMIN and TRIGger<m>:
CAN:DMAX.
*RST: EQUal
TRIGger<m>:
CAN:DMIN <DataPattern>
Specifies a data pattern, or sets the the start value of a data pattern range.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<DataPattern>
Numeric or string pattern, see chapter 16.2.2.6, "Bit Pattern
Parameter", on page 421. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:CAN:DMAX <DataPatternTo>
Sets the the end value of an data range if TRIGger<m>:CAN:DCONdition is set to
INRange or OORange.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<DataPatternTo>
Numeric or string pattern, see chapter 16.2.2.6, "Bit Pattern
Parameter", on page 421. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:CAN:BORDer <Endianness>
Sets the byte order (endianess) of the data transfer.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Command Reference