User manual

Remote Control
R&S
®
RTO
688User Manual 1316.0827.02 ─ 06
TRIGger<m>:CAN:DLC..................................................................................................692
TRIGger<m>:CAN:ACKerror...........................................................................................692
TRIGger<m>:CAN:BITSterror..........................................................................................693
TRIGger<m>:CAN:CRCerror...........................................................................................693
TRIGger<m>:CAN:FORMerror........................................................................................693
TRIGger<m>:CAN:TYPE <Type>
Selects the trigger type for LIN analysis.
See: "Trigger type" on page 289.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<Type> STOF | FTYP | ID | IDDT | ERRC
STOF
STart Of Frame: triggers on the first edge of the dominant SOF bit
(synchronization bit).
FTYP
Frame TYPe: triggers on a specified frame type (data, remote,
error, or overload) and on the identifier format.
To set the frame type, use TRIGger<m>:CAN:FTYPe. ´Set the
identifier format with TRIGger<m>:CAN:ITYPe
ID
IDentifier: Sets the trigger to one specific identifier or an identifier
range. To set the identifier, use TRIGger<m>:CAN:
ICONdition, TRIGger<m>:CAN:IMIN, and TRIGger<m>:
CAN:IMAX.
IDDT
IDentifier and DaTa: Combination of identifier and data conditions
To set the identifier condition, use TRIGger<m>:CAN:
ICONdition, TRIGger<m>:CAN:IMIN, and TRIGger<m>:
CAN:IMAX.
To set the data condition, use TRIGger<m>:CAN:DCONdition,
TRIGger<m>:CAN:DMIN, and TRIGger<m>:CAN:DMAX.
ERRC
ERRor Condition: Define the error types with TRIGger<m>:
CAN:ACKerror, TRIGger<m>:CAN:BITSterror, 
TRIGger<m>:CAN:CRCerror, and TRIGger<m>:CAN:
FORMerror.
*RST:
STOF
TRIGger<m>:CAN:FTYPe <FrameType>
Selects the CAN frame type.
Command Reference