User manual

Remote Control
R&S
®
RTO
687User Manual 1316.0827.02 ─ 06
BUS<m>:CAN:T1Segment <TimeSeg1>
BUS<m>:CAN:T2Segment <TimeSeg2>
Set the number of time quanta before the sample point (T1Segment) and after the sample
point (T2Segment). T1Segment comprises the segments Synch_seg, Prop_seg, and
Phase_seg1 which are specified in the CAN standard. T2Segment matches Phase_seg2
specified in the CAN standard.
Make sure to set both values for correct definition of the sample point. Alternatively, you
can use BUS<m>:CAN:SAMPlepoint.
See also: "Synchronization: Sample point, Time segments, Jump width" on page 287
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<TimeSeg2> Time quanta
Range: 1 to 25
Increment: 1
*RST: 5
BUS<m>:CAN:JWIDth <JumpWidth>
Defines the maximum number of time quanta for phase correction. Time segment1 may
be lengthened or Time segment2 may be shortened due to resynchronization. Resynch-
ronization corrects the phase error of an edge caused by the drift of the oscillators.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<JumpWidth> Time quanta
Range: 1 to 25
Increment: 1
*RST: 1
CAN Trigger
TRIGger<m>:CAN:TYPE................................................................................................688
TRIGger<m>:CAN:FTYPe...............................................................................................688
TRIGger<m>:CAN:ITYPe................................................................................................689
TRIGger<m>:CAN:ICONdition.........................................................................................689
TRIGger<m>:CAN:IMIN..................................................................................................690
TRIGger<m>:CAN:IMAX.................................................................................................690
TRIGger<m>:CAN:DCONdition.......................................................................................690
TRIGger<m>:CAN:DMIN................................................................................................691
TRIGger<m>:CAN:DMAX...............................................................................................691
TRIGger<m>:CAN:BORDer............................................................................................691
TRIGger<m>:CAN:DLCCondition.....................................................................................692
Command Reference