User manual

Remote Control
R&S
®
RTO
684User Manual 1316.0827.02 ─ 06
Return values:
<WordState> OK | FRSTart | FRENd | FRME | BREak | STERror | SPERror |
PRERror | INSufficient
OK: the frame is valid.
BREak:stop bit error with 0x00 word
STERror: StarT ERror, incorrect start bit
SPERror: StoP ERror, incorrect stop bit
PRERror:PaRity ERror, incorrect parity bit.
INSufficient: The frame is not completely contained in the acqui-
sition. The acquired part of the frame is valid.
*RST: OK
Usage: Query only
16.2.14.5
CAN (Option R&S RTO-K3)
● CAN Configuration................................................................................................684
● CAN Trigger..........................................................................................................687
● CAN Decoding Results.........................................................................................694
● Translation............................................................................................................700
CAN Configuration
BUS<m>:CAN:DATA:SOURce........................................................................................684
BUS<m>:CAN:TYPE......................................................................................................685
BUS<m>:CAN:DATA:THReshold.....................................................................................685
BUS<m>:CAN:TECHnology............................................................................................685
BUS<m>:CAN:BITRate...................................................................................................686
BUS<m>:CAN:SAMPlepoint............................................................................................686
BUS<m>:CAN:T1Segment..............................................................................................687
BUS<m>:CAN:T2Segment..............................................................................................687
BUS<m>:CAN:JWIDth....................................................................................................687
BUS<m>:CAN:DATA:SOURce <DataSource>
Sets the source of the data line that is selected with BUS<m>:CAN:TYPE.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<DataSource> NONE | C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | R1 |
R2 | R3 | R4
*RST: NONE
Usage: Asynchronous command
Command Reference