User manual

Remote Control
R&S
®
RTO
682User Manual 1316.0827.02 ─ 06
Parameters:
<Data>
Numeric or string pattern, see chapter 16.2.2.6, "Bit Pattern
Parameter", on page 421. The string parameter accepts the bit
value X (don't care).
Usage: Asynchronous command
Decoding Results (Option R&S RTO-K1)
BUS<m>:UART:WORD<n>:RXValue...............................................................................682
BUS<m>:UART:WORD<n>:TXValue...............................................................................682
BUS<m>:UART:WORD<n>:COUNt.................................................................................682
BUS<m>:UART:WORD<n>:SOURce...............................................................................683
BUS<m>:UART:WORD<n>:STARt..................................................................................683
BUS<m>:UART:WORD<n>:STATe..................................................................................683
BUS<m>:UART:WORD<n>:RXValue?
BUS<m>:UART:WORD<n>:TXValue?
Returns the value of the specified word on the Rx line or Tx line, respectively.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
Selects the word.
Return values:
<RxValue>
<TxValue>
To set the value format, use FORMat:BPATtern.
The values below – range, increment and reset – are decimal val-
ues.
Range: 0 to 255
Increment: 1
*RST: 0
Usage: Query only
BUS<m>:UART:WORD<n>:COUNt?
Returns the number of words in the acquisition.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
The suffix is irrelevant.
Return values:
<Count> Number of words
Usage: Query only
Command Reference