User manual

Remote Control
R&S
®
RTO
680User Manual 1316.0827.02 ─ 06
TRIGger<m>:UART:DATA..............................................................................................681
TRIGger<m>:UART:TYPE <Type>
Selects the trigger type for UART analysis.
See also: "Type" on page 282
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<Type> STBT | PCKS | DATA | PRER | BRKC | STPerror
STBT: Start bit
PCKS: Packet start
DATA: Serial pattern
PRER: Parity error
BRKC: Break condition
STPerror: Stop error
*RST: STBT
Usage: Asynchronous command
TRIGger<m>:UART:SOURce <Source>
Selects the transmitter or receiver line as trigger source.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<Source> TX | RX
*RST: TX
Usage: Asynchronous command
TRIGger<m>:UART:DPOPerator <DataPosiOperator>
Sets the operator for the data position. You can defined an exact position, or a position
range.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<DataPosiOperator> EQUal | NEQual | GETHan | INRange
*RST: GETHan
Usage: Asynchronous command
Command Reference