User manual

Remote Control
R&S
®
RTO
679User Manual 1316.0827.02 ─ 06
BUS<m>:UART:POLarity <Polarity>
Defines the idle state of the bus. The idle state corresponds to a logic 1. The transmitted
data on the bus is high (high = 1) or low (low = 1) active.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<Polarity> IDLLow | IDLHigh
*RST: IDLHigh
Usage: Asynchronous command
BUS<m>:
UART:SBIT <StopBits>
Sets the number of stop bits: 1; 1.5 or 2 stop bits are possible.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<StopBits> B1 | B1_5 | B2
*RST: B1
Usage: Asynchronous command
BUS<m>:UART:SSIZe <DataBits>
Sets the number of data bits in a message.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<DataBits> Number of data bits
Range: 5 to 8
Increment: 1
*RST: 8
Usage: Asynchronous command
UART Trigger
TRIGger<m>:UART:TYPE..............................................................................................680
TRIGger<m>:UART:SOURce..........................................................................................680
TRIGger<m>:UART:DPOPerator.....................................................................................680
TRIGger<m>:UART:DPOSition........................................................................................681
TRIGger<m>:UART:DPTO..............................................................................................681
TRIGger<m>:UART:FCONdition......................................................................................681
Command Reference