User manual

Remote Control
R&S
®
RTO
676User Manual 1316.0827.02 ─ 06
Parameters:
<RxSource> NONE | C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | R1 |
R2 | R3 | R4
See chapter 16.2.2.2, "Waveform Parameter", on page 419
*RST: NONE
Usage: Asynchronous command
BUS<m>:UART:TX:SOURce <TxSource>
Selects the input channel for the transmitter signal.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<TxSource> NONE | C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | R1 |
R2 | R3 | R4
See chapter 16.2.2.2, "Waveform Parameter", on page 419
*RST: NONE
Usage: Asynchronous command
BUS<m>:UART:RX:THReshold <RxThreshold>
Sets a user-defined threshold value for the Rx line.
Alternatively, you can set the threshold according to the signal technology with 
BUS<m>:UART:TECHnology.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<RxThreshold> User-defined clock threshold
Range: -12 to 12
Increment: 0.1
*RST: 0
Default unit: V
BUS<m>:UART:TX:THReshold <TxThreshold>
Sets a user-defined threshold value for the Tx line.
Alternatively, you can set the threshold according to the signal technology with 
BUS<m>:UART:TECHnology.
Command Reference