User manual
Remote Control
R&S
®
RTO
675User Manual 1316.0827.02 ─ 06
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
Selects the frame.
<o> *
Selects the word number.
Return values:
<MOSIValue>
To set the value format, use FORMat:BPATtern.
The values below – range, increment and reset – are decimal val-
ues.
Range: 0 to 4294967295
Increment: 1
*RST: 0
Usage: Query only
16.2.14.4 UART
● UART Configuration..............................................................................................675
● UART Trigger........................................................................................................679
● Decoding Results (Option R&S RTO-K1).............................................................682
UART Configuration
BUS<m>:UART:RX:SOURce..........................................................................................675
BUS<m>:UART:TX:SOURce...........................................................................................676
BUS<m>:UART:RX:THReshold.......................................................................................676
BUS<m>:UART:TX:THReshold.......................................................................................676
BUS<m>:UART:TECHnology..........................................................................................677
BUS<m>:UART:BITRate.................................................................................................677
BUS<m>:UART:BAUDrate..............................................................................................678
BUS<m>:UART:PARity...................................................................................................678
BUS<m>:UART:BITime..................................................................................................678
BUS<m>:UART:POLarity................................................................................................679
BUS<m>:UART:SBIT.....................................................................................................679
BUS<m>:UART:SSIZe...................................................................................................679
BUS<m>:UART:RX:SOURce <RxSource>
Selects the input channel for the receiver signal.
Suffix:
<m>
.
1..4
Selects the serial bus.
Command Reference