User manual

Remote Control
R&S
®
RTO
666User Manual 1316.0827.02 ─ 06
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<MOSIsource> NONE | C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | R1 |
R2 | R3 | R4
See chapter 16.2.2.2, "Waveform Parameter", on page 419
*RST: NONE
Usage: Asynchronous command
BUS<m>:
SPI:MOSI:POLarity <MOSIPolarity>
Selects whether transmitted data is high active (high = 1) or low active (low = 1).
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<MOSIPolarity> ACTLow | ACTHigh
*RST: ACTHigh
Usage: Asynchronous command
BUS<m>:SPI:TECHnology <Technology>
Sets the threshold voltage clock, slave select and data lines as defined for various signal
technologies.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<Technology> V15 | V25 | V165 | V125 | V09 | VM13 | V38 | V20 | V0 | MAN
V15 | V25 | V165 | V125 | V09 | V38 | V20 | V0
1.5 V, 2.5 V, 1.65 V ... respectively
VM13
-1.3 V (negative value)
MAN
Manual setting of user-defined values with
BUS<m>:SPI:SCLK|SSEL|MISO|MOSI:THReshold.
*RST: V165
Usage: SCPI confirmed
Command Reference