User manual

Remote Control
R&S
®
RTO
665User Manual 1316.0827.02 ─ 06
BUS<m>:SPI:SSELect:POLarity <SSPolarity>
Selects whether transmitted slave select signal is high active (high = 1) or low active (low
= 1).
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<SSPolarity> ACTLow | ACTHigh
*RST: ACTLow
Usage: Asynchronous command
BUS<m>:
SPI:MISO:SOURce <MISOsource>
Sets the input channel of the MISO line.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<MISOsource> NONE | C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | R1 |
R2 | R3 | R4
See chapter 16.2.2.2, "Waveform Parameter", on page 419
*RST: NONE
Usage: Asynchronous command
BUS<m>:SPI:MISO:POLarity <MISOPolarity>
Selects whether transmitted data is high active (high = 1) or low active (low = 1).
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<MISOPolarity> ACTLow | ACTHigh
*RST: ACTHigh
Usage: Asynchronous command
BUS<m>:SPI:MOSI:SOURce <MOSIsource>
Sets the input channel of the MOSI line.
Command Reference