User manual

Remote Control
R&S
®
RTO
654User Manual 1316.0827.02 ─ 06
Parameters:
<DataPattern>
Numeric or string pattern, see chapter 16.2.2.6, "Bit Pattern
Parameter", on page 421. The string parameter accepts the bit
value X (don't care).
Usage: Asynchronous command
Firmware/Software: V 1.30
TRIGger<m>:I2C:DMAX <DataTo>
Sets the the end value of an data range if TRIGger<m>:I2C:DCONdition is set to
INRange or OORange.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<DataPatternTo>
Numeric or string pattern, see chapter 16.2.2.6, "Bit Pattern
Parameter", on page 421. The string parameter accepts the bit
value X (don't care).
Usage: Asynchronous command
Firmware/Software: V 1.30
Decoding Results (Option R&S RTO-K1)
BUS<m>:I2C:FRAMe<n>:DATA......................................................................................655
BUS<m>:I2C:FCOunt.....................................................................................................655
BUS<m>:I2C:FRAMe<n>:AACCess.................................................................................655
BUS<m>:I2C:FRAMe<n>:ACCess...................................................................................655
BUS<m>:I2C:FRAMe<n>:ACOMplete..............................................................................656
BUS<m>:I2C:FRAMe<n>:ADBStart.................................................................................656
BUS<m>:I2C:FRAMe<n>:ADDRess.................................................................................656
BUS<m>:I2C:FRAMe<n>:ADEVice..................................................................................657
BUS<m>:I2C:FRAMe<n>:AMODe...................................................................................657
BUS<m>:I2C:FRAMe<n>:ASTart.....................................................................................658
BUS<m>:I2C:FRAMe<n>:RWBStart................................................................................658
BUS<m>:I2C:FRAMe<n>:STATus...................................................................................658
BUS<m>:I2C:FRAMe<n>:STARt.....................................................................................659
BUS<m>:I2C:FRAMe<n>:STOP......................................................................................659
BUS<m>:I2C:FRAMe<n>:BCOunt...................................................................................660
BUS<m>:I2C:FRAMe<n>:BYTE<o>:ACCess....................................................................660
BUS<m>:I2C:FRAMe<n>:BYTE<o>:ACKStart..................................................................660
BUS<m>:I2C:FRAMe<n>:BYTE<o>:COMPlete.................................................................661
BUS<m>:I2C:FRAMe<n>:BYTE<o>:STARt......................................................................661
BUS<m>:I2C:FRAMe<n>:BYTE<o>:VALue......................................................................662
Command Reference