User manual

Remote Control
R&S
®
RTO
652User Manual 1316.0827.02 ─ 06
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
<n> 1..4
Index of the address in an "address OR" condition (OR slot)
Parameters:
<Address>
Numeric or string pattern, see chapter 16.2.2.6, "Bit Pattern
Parameter", on page 421.
TRIGger<m>:I2C:ADOR<n>:RWBit <RWBit>
Defines the R/W bit of the indicated ADOR address in the "address OR" trigger condition.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
<n> 1..4
Index of the address in an "address OR" condition (OR slot)
Parameters:
<RWBit> UNDefined | READ | WRITe | EITHer
UNDefined
Return value only
*RST: EITHer
TRIGger<m>:I2C:DPOPerator <DataPosiOperator>
Sets the operator for the data position. You can defined an exact position, or a position
range.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<DataPosiOperator> ANY | EQUal | GETHan | RANGe
ANY
The position of the required pattern is not relevant.
EQUal | GETHan
Equal, Greater or equal than. These conditions require one data
position to be set with TRIGger<m>:I2C:DPOSition.
RANGe
In range: Set the minimum and maximum value of the range with 
TRIGger<m>:I2C:DPOSition and TRIGger<m>:I2C:DPTO.
*RST: ANY
Command Reference