User manual

Remote Control
R&S
®
RTO
651User Manual 1316.0827.02 ─ 06
TRIGger<m>:I2C:ADDTo <AddressTo>
Sets the the end value of an address range if the condition is set to an address range
with TRIGger<m>:I2C:ACONdition.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<AddressTo>
Numeric or string pattern, see chapter 16.2.2.6, "Bit Pattern
Parameter", on page 421.
Usage: Asynchronous command
TRIGger<m>:I2C:ADOR<n>:ENABle <UseAddress>
Includes the indicated ADOR address in the "address OR" trigger condition.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
<n> 1..4
Index of the address in an "address OR" condition (OR slot)
Parameters:
<UseAddress> ON | OFF
*RST: OFF
TRIGger<m>:I2C:ADOR<n>:ADRType <AddressType>
Sets the address type for the indicated ADOR address in the "address OR" trigger con-
dition.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
<n> 1..4
Index of the address in an "address OR" condition (OR slot)
Parameters:
<AddressType> BIT7 | BIT7_RW | BIT10
*RST: BIT7
TRIGger<m>:I2C:ADOR<n>[:VALue] <Address>
Defines the address pattern of the indicated ADOR address in the "address OR" trigger
condition.
Command Reference