User manual

Remote Control
R&S
®
RTO
650User Manual 1316.0827.02 ─ 06
Parameters:
<AddressType> BIT7 | BIT7_RW | BIT10 | ANY
Available address types depend on BUS<m>:I2C:RWBit SEPa-
rate | INADdress.
BIT7 | BIT10
Only address bits have to be entered for address.
BIT7_RW
Seven address bits and also the R/W bit have to be entered for
address.
ANY
Only available for trigger type "Address + data" (TRIGger<m>:
I2C:MODE ADAT). Used to trigger on data only, regardless of the
address.
*RST:
BIT7
Usage: Asynchronous command
TRIGger<m>:
I2C:ACONdition <AddressOperator>
Sets the operator to set a specific address or an address range. The address values are
set with TRIGger<m>:I2C:ADDRess and TRIGger<m>:I2C:ADDTo.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<AddressOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan | INRange |
OORange
*RST: EQUal
Firmware/Software: V 1.25
TRIGger<m>:I2C:ADDRess <Address>
Triggers on the specified slave address, or sets the the start value of an address range
depending on the condition set with TRIGger<m>:I2C:ACONdition.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<Address>
Numeric or string pattern, see chapter 16.2.2.6, "Bit Pattern
Parameter", on page 421.
Command Reference