User manual

Remote Control
R&S
®
RTO
647User Manual 1316.0827.02 ─ 06
BUS<m>:I2C:RWBit <BusConfig>
Defines if the R/W bit of a 7-bit address is considered separately or as part of the address.
The setting defines which address lengths are available with TRIGger<m>:I2C:
AMODe.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<BusConfig> SEParate | INADdress
SEParate
Address types BIT7 and BIT10 are available.
INADdress
Address types BIT7_RW and BIT10 are available.
*RST: SEParate
Firmware/Software: FW 1.35
Trigger
TRIGger<m>:I2C:MODE.................................................................................................647
TRIGger<m>:I2C:ACCess...............................................................................................648
TRIGger<m>:I2C:ADNack...............................................................................................648
TRIGger<m>:I2C:DWNack..............................................................................................649
TRIGger<m>:I2C:DRNack..............................................................................................649
TRIGger<m>:I2C:AMODe...............................................................................................649
TRIGger<m>:I2C:ACONdition.........................................................................................650
TRIGger<m>:I2C:ADDRess............................................................................................650
TRIGger<m>:I2C:ADDTo................................................................................................651
TRIGger<m>:I2C:ADOR<n>:ENABle...............................................................................651
TRIGger<m>:I2C:ADOR<n>:ADRType.............................................................................651
TRIGger<m>:I2C:ADOR<n>[:VALue]...............................................................................651
TRIGger<m>:I2C:ADOR<n>:RWBit.................................................................................652
TRIGger<m>:I2C:DPOPerator.........................................................................................652
TRIGger<m>:I2C:DPOSition...........................................................................................653
TRIGger<m>:I2C:DPTO..................................................................................................653
TRIGger<m>:I2C:DCONdition.........................................................................................653
TRIGger<m>:I2C:DMIN..................................................................................................653
TRIGger<m>:I2C:DMAX.................................................................................................654
TRIGger<m>:I2C:MODE <Type>
Selects the trigger type for I²C analysis.
See: "Trigger type" on page 262
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Command Reference