User manual

Remote Control
R&S
®
RTO
645User Manual 1316.0827.02 ─ 06
Configuration
BUS<m>:I2C:SCL:SOURce............................................................................................645
BUS<m>:I2C:SDA:SOURce............................................................................................645
BUS<m>:I2C:SCL:THReshold.........................................................................................645
BUS<m>:I2C:SDA:THReshold.........................................................................................646
BUS<m>:I2C:TECHnology..............................................................................................646
BUS<m>:I2C:RWBit.......................................................................................................647
BUS<m>:I2C:SCL:SOURce <SCLSource>
Sets the waveform of the clock line.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<SCLSource> NONE | C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | R1 |
R2 | R3 | R4
See chapter 16.2.2.2, "Waveform Parameter", on page 419
*RST: NONE
Usage: Asynchronous command
BUS<m>:I2C:SDA:SOURce <SDASource>
Sets the waveform of the data line.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<SDASource> NONE | C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | R1 |
R2 | R3 | R4
See chapter 16.2.2.2, "Waveform Parameter", on page 419
*RST: NONE
Usage: Asynchronous command
BUS<m>:I2C:SCL:THReshold <SCLThreshold>
Sets a user-defined threshold value for the clock line.
Alternatively, you can set the threshold according to the signal technology with 
BUS<m>:I2C:TECHnology.
Command Reference