User manual
Remote Control
R&S
®
RTO
643User Manual 1316.0827.02 ─ 06
SEARch:TRIGger:LEVel:NOISe[:STATe] <Key>, <SignalSource>, <State>
SEARch:TRIGger:LEVel:NOISe[:STATe]? <Key>, <SignalSource>
If enabled, the noise reject settings for the waveform are considered for the search.
Parameters:
<State> ON | OFF
Parameters for setting and query:
<Key> Search definition
<SignalSource> NONE | C1W1 | C1W2 | C1W3 | C2W1 | C2W2 | C2W3 | C3W1 |
C3W2 | C3W3 | C4W1 | C4W2 | C4W3 | M1 | M2 | M3 | M4 | R1 |
R2 | R3 | R4
Source of the search, see chapter 16.2.2.2, "Waveform Parame-
ter", on page 419
*RST: NONE
Usage: SCPI confirmed
16.2.14 Protocols
● General Setup.......................................................................................................643
● I²C ........................................................................................................................644
● SPI........................................................................................................................663
● UART....................................................................................................................675
●
CAN (Option R&S RTO-K3)..................................................................................684
●
LIN (Option R&S RTO-K3)....................................................................................701
●
FlexRay (Option R&S RTO-K4)............................................................................717
16.2.14.1 General Setup
See also: FORMat:BPATtern on page 427.
BUS<m>:TYPE..............................................................................................................643
BUS<m>[:STATe]..........................................................................................................644
BUS<m>:LABel..............................................................................................................644
BUS<m>:RESult............................................................................................................644
BUS<m>:TYPE <Type>
Defines the bus or protocol type for analysis.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<Type> I2C | SPI | UART | CAN | LIN
*RST: I2C
Command Reference