User manual

Remote Control
R&S
®
RTO
642User Manual 1316.0827.02 ─ 06
<SignalSource> NONE | C1W1 | C1W2 | C1W3 | C2W1 | C2W2 | C2W3 | C3W1 |
C3W2 | C3W3 | C4W1 | C4W2 | C4W3 | M1 | M2 | M3 | M4 | R1 |
R2 | R3 | R4
Source of the search, see chapter 16.2.2.2, "Waveform Parame-
ter", on page 419
*RST: NONE
Usage: SCPI confirmed
SEARch:TRIGger:LEVel:NOISe:MODE <Key>, <SignalSource>, <Mode>
SEARch:TRIGger:LEVel:NOISe:MODE? <Key>, <SignalSource>
Defines whether absolute values or relative values to the vertical scaling are used as a
hysteresis for noise rejection.
Parameters:
<Mode> ABS | REL
Parameters for setting and query:
<Key> Search definition
<SignalSource> NONE | C1W1 | C1W2 | C1W3 | C2W1 | C2W2 | C2W3 | C3W1 |
C3W2 | C3W3 | C4W1 | C4W2 | C4W3 | M1 | M2 | M3 | M4 | R1 |
R2 | R3 | R4
Source of the trigger waveform, see chapter 16.2.2.2, "Waveform
Parameter", on page 419
*RST: NONE
Usage: SCPI confirmed
SEARch:TRIGger:LEVel:NOISe:RELative <Key>, <SignalSource>, <Value>
Defines a range around the trigger level in relative values. If the signal jitters inside this
range and crosses the trigger level, no trigger event is detected.
Parameters:
<Value> Hysteresis value in %
Setting parameters:
<Key> Search definition
<SignalSource> NONE | C1W1 | C1W2 | C1W3 | C2W1 | C2W2 | C2W3 | C3W1 |
C3W2 | C3W3 | C4W1 | C4W2 | C4W3 | M1 | M2 | M3 | M4 | R1 |
R2 | R3 | R4
Source of the search, see chapter 16.2.2.2, "Waveform Parame-
ter", on page 419
*RST: NONE
Usage: SCPI confirmed
Command Reference