User manual

Remote Control
R&S
®
RTO
641User Manual 1316.0827.02 ─ 06
SEARch:RESult[:ALL]? <SearchName>
Returns all search results.
Query parameters:
<SearchName> Search definition
Return values:
<Data> List of search results, separated by commas. For each result, six
values are returned:
1. Acquisition index, currently always 0.
2. X-position of the search result
3. Y-position of the search result, currently not relevant
4. Type of the search result (Edge, Glitch, ...)
5. Slope or polarity of the search result
6. For runt, glitch, width, and window searches, the value contains
the width. For timeout and interval searches, it contains the time-
out. For transition searches, it contains the slew rate. For all other
searches, the value is not relevant.
If a value is not relevant, 9.91E+37 is returned.
Example:
SEAR:RES? 'Search1'
0,1.5375e-007,-84,Edge,Positive,9.91E+37,
0,5.3e-008,-84,Edge,Positive,9.91E+37
The query returns two search results for edge search on rising
edges at X-position 153,75 ns and 53 ns.
Usage: Query only
SCPI confirmed
16.2.13.7 Noise Rejection
SEARch:TRIGger:LEVel:NOISe:ABSolute........................................................................641
SEARch:TRIGger:LEVel:NOISe:MODE............................................................................642
SEARch:TRIGger:LEVel:NOISe:RELative........................................................................642
SEARch:TRIGger:LEVel:NOISe[:STATe]..........................................................................643
SEARch:TRIGger:LEVel:NOISe:ABSolute <Key>, <SignalSource>, <Value>
Defines the trigger hysteresis, a range in absolute values around the trigger level. If the
signal jitters inside this range and crosses the trigger level, no trigger event is detected.
Parameters:
<Value> Hysteresis value
Setting parameters:
<Key> Search definition
Command Reference