User manual

Remote Control
R&S
®
RTO
632User Manual 1316.0827.02 ─ 06
Parameters:
<Value> Voltage value
Parameters for setting and query:
<Key> Search definition
<SignalSource> NONE | C1W1 | C1W2 | C1W3 | C2W1 | C2W2 | C2W3 | C3W1 |
C3W2 | C3W3 | C4W1 | C4W2 | C4W3 | M1 | M2 | M3 | M4 | R1 |
R2 | R3 | R4
Source of the search, see chapter 16.2.2.2, "Waveform Parame-
ter", on page 419
*RST: NONE
SEARch:
TRIGger:FINDlevel <SearchName>
Sets the trigger level automatically to 0.5 * (MaxPeak – MinPeak). The function is not
available for an external trigger source.
Setting parameters:
<SearchName> Search definition
Usage: Setting only
SCPI confirmed
16.2.13.5 Search Scope Settings
SEARch:GATE[:STATe]..................................................................................................632
SEARch:GATE:MODE....................................................................................................633
SEARch:GATE:SHOW...................................................................................................633
SEARch:GATE:ABSolute:STARt.....................................................................................633
SEARch:GATE:ABSolute:STOP......................................................................................633
SEARch:GATE:RELative:STARt......................................................................................634
SEARch:GATE:RELative:STOP.......................................................................................634
SEARch:GATE:ZCOupling..............................................................................................634
SEARch:HISTory:ALL.....................................................................................................635
SEARch:HISTory:STARt.................................................................................................635
SEARch:HISTory:STOP..................................................................................................635
SEARch:HISTory[:STATe]..............................................................................................635
SEARch:GATE[:STATe] <SearchName>,<State>
SEARch:GATE[:STATe]? <SearchName>
Performs the search only on the defined gate area of the source waveform.
Parameters:
<State> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName> Search definition
Command Reference