User manual

Remote Control
R&S
®
RTO
625User Manual 1316.0827.02 ─ 06
SEARch:TRIGger:SLEWrate:TIME <SearchName>,<Time>
SEARch:TRIGger:SLEWrate:TIME? <SearchName>
For the ranges "Within" and "Outside", the slew rate defines the center of a range which
is defined by the limits "±Delta".
For the ranges "Shorter" and "Longer", the slew rate defines the maximum and minimum
slew rate limits, respectively.
The range is defined using SEARch:TRIGger:SLEWrate:RANGe.
Parameters:
<Time> Range: 100E-12 to 864
Increment: 100E-9
*RST: 100E-12
Default unit: s
Parameters for setting and query:
<SearchName> Search definition
Usage: SCPI confirmed
SEARch:TRIGger:LEVel:TRANsition:LOWer <Key>, <SignalSource>, <Value>
SEARch:TRIGger:LEVel:TRANsition:LOWer? <Key>, <SignalSource>
Sets the lower voltage threshold. When the signal crosses this level, the slew rate mea-
surement starts or stops depending on the selected slope.
Parameters:
<Value> Voltage value
Parameters for setting and query:
<Key> Search definition
<SignalSource> NONE | C1W1 | C1W2 | C1W3 | C2W1 | C2W2 | C2W3 | C3W1 |
C3W2 | C3W3 | C4W1 | C4W2 | C4W3 | M1 | M2 | M3 | M4 | R1 |
R2 | R3 | R4
Source of the search, see chapter 16.2.2.2, "Waveform Parame-
ter", on page 419
*RST: NONE
Usage: SCPI confirmed
SEARch:TRIGger:LEVel:TRANsition:UPPer <Key>, <SignalSource>, <Value>
SEARch:TRIGger:LEVel:TRANsition:UPPer? <Key>, <SignalSource>
Sets the upper voltage threshold. When the signal crosses this level, the slew rate mea-
surement starts or stops depending on the selected slope.
Parameters:
<Value> Voltage value
Command Reference