User manual

Remote Control
R&S
®
RTO
619User Manual 1316.0827.02 ─ 06
You need to know the expected pulse widths of the circuit to set the glitch width correctly.
Parameters:
<Width> Range: 100E-12 to 1E-3
Increment: 100E-6
*RST: 1E-9
Default unit: s
Parameters for setting and query:
<SearchName> Search definition
Usage: SCPI confirmed
Interval
SEARch:TRIGger:INTerval:DELTa...................................................................................619
SEARch:TRIGger:INTerval:POLarity................................................................................619
SEARch:TRIGger:INTerval:RANGe.................................................................................620
SEARch:TRIGger:INTerval:WIDTh...................................................................................620
SEARch:TRIGger:INTerval:DELTa <SearchName>,<WidthDelta>
SEARch:TRIGger:INTerval:DELTa? <SearchName>
Defines a range around the "Interval width" value (see SEARch:TRIGger:
INTerval:WIDTh on page 620).
Parameters:
<WidthDelta> Range: 0 to 10
Increment: 100E-9
*RST: 0
Default unit: s
Parameters for setting and query:
<SearchName> Search definition
Usage: SCPI confirmed
SEARch:TRIGger:INTerval:POLarity <SearchName>,<Polarity>
SEARch:TRIGger:INTerval:POLarity? <SearchName>
Indicates the polarity of a pulse, that is the direction of the first pulse slope.
Parameters:
<Polarity> POSitive | NEGative | EITHer
See chapter 16.2.2.4, "Polarity Parameter", on page 420.
*RST: POSitive
Parameters for setting and query:
<SearchName> Search definition
Usage: SCPI confirmed
Command Reference