User manual

Remote Control
R&S
®
RTO
609User Manual 1316.0827.02 ─ 06
MTESt:RESult:COUNt:FWAVeforms................................................................................610
MTESt:RESult:COUNt:FAILures......................................................................................610
MTESt:RESult:FRATe....................................................................................................610
MTESt:RESult:STATe? <MaskTestName>
Shows if the test is running or has finished. The state is set to "Finished" if no acquisitions
remain (see MTESt:RESult:COUNt:REMaining on page 609).
Query parameters:
<MaskTestName>
Return values:
<State> RUNNing | FINished
*RST: RUNNing
Usage: Query only
MTESt:RESult[:RESult]? <MaskTestName>
Returns the test result.
A test has failed if the number of sample hits or acquisition hits exceeds the limit of
"Violation tolerance" hits (see MTESt:TOLerance on page 599, MTESt:RESult:
COUNt:FAILures on page 610 and MTESt:RESult:COUNt:FWAVeforms
on page 610).
Query parameters:
<MaskTestName>
Return values:
<TestResult> PASS | FAIL
*RST: PASS
Usage: Query only
MTESt:RESult:COUNt:WAVeforms? <MaskTestName>
Returns the number of tested acquisitions.
Query parameters:
<MaskTestName>
Return values:
<AcqsCompleted> Range: 0 to 100E+24
Increment: 1
*RST: 0
Usage: Query only
MTESt:RESult:COUNt:REMaining? <MaskTestName>
Remaining acquisitions until "Average count / Nx Single count" is reached.
Command Reference