User manual

Remote Control
R&S
®
RTO
600User Manual 1316.0827.02 ─ 06
Parameters:
<DefinitionType> USER | WFML
USER
The mask segments are created by entering the numerical x- and
y-values of the mask points.
See: chapter 16.2.12.2, "Mask Definition: User
Mask", on page 600
WFML
The mask is created from the envelope of an existing waveform.
See: chapter 16.2.12.3, "Mask Definition: Waveform
Mask", on page 605
*RST: USER
Parameters for setting and query:
<MaskTestName> String containing the name of the mask test
16.2.12.2
Mask Definition: User Mask
The chapter contains commands required for the definition of user masks - MTESt:
CTYPe is set to USER.
MTESt:SEGMent:STATe................................................................................................600
MTESt:SEGMent:ADD....................................................................................................601
MTESt:SEGMent:COUNt................................................................................................601
MTESt:SEGMent:INSert.................................................................................................601
MTESt:SEGMent:REMove..............................................................................................601
MTESt:SEGMent:REGion...............................................................................................601
MTESt:SEGMent:POINt:ADD..........................................................................................602
MTESt:SEGMent:POINt:INSert........................................................................................602
MTESt:SEGMent:POINt:REMove....................................................................................602
MTESt:SEGMent:POINt:COUNt......................................................................................603
MTESt:SEGMent:POINt:X...............................................................................................603
MTESt:SEGMent:POINt:Y...............................................................................................603
MTESt:SEGMent:RESCale:RECalculate..........................................................................604
MTESt:SEGMent:RESCale:XFACtor................................................................................604
MTESt:SEGMent:RESCale:YFACtor................................................................................604
MTESt:SEGMent:RESCale:XOFFset...............................................................................605
MTESt:SEGMent:RESCale:YOFFset...............................................................................605
MTESt:SEGMent:STATe <MaskTestName>, <MaskSegmIdx>,<State>
MTESt:SEGMent:STATe? <MaskTestName>, <MaskSegmIdx>
Enables and disables the mask segment. Disabled segments are not considered by run-
ning tests.
Parameters:
<State> ON | OFF
*RST: ON
Command Reference