User manual

Acquisition and Setup
R&S
®
RTO
44User Manual 1316.0827.02 ─ 06
Fig. 2-11: Probe setup for current probes
Make sure that the correct channel tab is selected.
Show channel
Switches the channel signal on or off. The signal icon appears on the signal bar. The
waveform of the last acquisition is displayed in the diagram.
SCPI command:
CHANnel<m>:STATe on page 436
Type, Name, Input impedance, Bandwidth
Voltage probes provided by R&S, and also many other passive voltage probes, are rec-
ognized by the instrument. The fields show the characteristics of a recognized probe for
information.
SCPI command:
PROBe<m>:SETup:TYPE on page 446
PROBe<m>:SETup:NAME on page 446
PROBe<m>:SETup:IMPedance on page 447
PROBe<m>:SETup:BANDwidth on page 447
Probe detection
If the probe was recognized by the instrument, the "Auto" mini-tab shows the detected
"Probe unit" and "Auto Attenuation".
For passive probes, it is possible to correct the detected values by entries on the "Man-
ual" mini-tab.
Reference for Acquisition and Setup