User manual

Remote Control
R&S
®
RTO
583User Manual 1316.0827.02 ─ 06
Suffix:
<m>
.
1...4
Selects the math waveform.
Parameters:
<Arithmetics> OFF | ENVelope | AVERage
*RST: OFF
CALCulate:MATH<m>:FFT:FRAMe:COVerage?
Due to the restriction of the number of frames (see CALCulate:MATH<m>:FFT:
FRAMe:MAXCount on page 583), the waveform may only be analyzed partially. This
command queries the percentage of the trace that was analyzed, i.e. which part of the
trace was included in the frame calculation.
Suffix:
<m>
.
1...4
math waveform
Return values:
<FrameCoverage> Range: 0 to 100
Increment: 1
*RST: 100
Default unit: %
Usage: Query only
SCPI confirmed
CALCulate:MATH<m>:FFT:FRAMe:MAXCount <MaxFrameCount>
Restricts the maximum number of frames to be calculated. Due to the other parameter
settings, the required number of frames may become very high, thus slowing perform-
ance. By restricting the number of frames, you can avoid performance loss without
changing the other parameters.
Suffix:
<m>
.
1...4
math waveform
Parameters:
<MaxFrameCount> Range: 1 to 10000
Increment: 10
*RST: 1000
Usage: SCPI confirmed
CALCulate:MATH<m>:FFT:FRAMe:OFACtor <OverlapFactor>
Defines the minimum factor by which two neighboring frames overlap. If the required
number of frames to cover the input values allows for more overlap, the factor is
increased.
Command Reference