User manual
Remote Control
R&S
®
RTO
578User Manual 1316.0827.02 ─ 06
CALCulate:MATH<m>:FFT:GATE:RELative:STARt...........................................................585
CALCulate:MATH<m>:FFT:GATE:RELative:STOP............................................................585
CALCulate:MATH<m>:FFT:GATE:SHOW........................................................................585
CALCulate:MATH<m>:FFT:GATE:ZCOupling...................................................................586
CALCulate:MATH<m>:FFT:GATE[:STATe].......................................................................586
CALCulate:MATH<m>:FFT:MAGNitude:LEVel..................................................................586
CALCulate:MATH<m>:FFT:MAGNitude:RANGe...............................................................586
CALCulate:MATH<m>:FFT:MAGNitude:SCALe................................................................587
CALCulate:MATH<m>:FFT:PHASe:SCALe.......................................................................587
CALCulate:MATH<m>:FFT:PHASe:SUPPression..............................................................587
CALCulate:MATH<m>:FFT:PHASe:THReshold.................................................................588
CALCulate:MATH<m>:FFT:PHASe:UNWRap...................................................................588
CALCulate:MATH<m>:FFT:STARt <StartFreq>
Defines the start frequency of the displayed frequency span.
Suffix:
<m>
.
1..4
math waveform
Parameters:
<StartFreq> start frequency
Range: 0 to 5E+9
Increment: 1
*RST: 2E+9
Default unit: Hz
CALCulate:MATH<m>:FFT:STOP <StopFreq>
Defines the stop frequency of the displayed frequency span.
Suffix:
<m>
.
1..4
math waveform
Parameters:
<StopFreq> stop frequency
Range: 0 to 5E+9
Increment: 1
*RST: 2E+9
Default unit: Hz
CALCulate:MATH<m>:FFT:WINDow:TYPE <WindowType>
Windowing helps minimize the discontinuities at the end of the measured signal interval
and thus reduces the effect of spectral leakage, increasing the frequency resolution.
Command Reference