User manual

Remote Control
R&S
®
RTO
573User Manual 1316.0827.02 ─ 06
MEASurement<m>:GATE:RELative:STARt <RelativeStart>
MEASurement<m>:GATE:RELative:STOP <RelativeStop>
Define the relative start and end values for the gate, respectively.
Suffix:
<m>
.
1..9
See "Measurement selection: MEASurement<m>" on page 522.
Parameters:
<RelativeStart>
<RelativeStop>
Range: 0 to 100
Increment: 0.1
*RST: 100
Default unit: %
Usage: SCPI confirmed
MEASurement<m>:GATE:NOISe <NoiseEvalArea>
Suffix:
<m>
.
1..9
See "Measurement selection: MEASurement<m>" on page 522.
Parameters:
<NoiseEvalArea> UPPer | LOWer
*RST: LOWer
MEASurement<m>:GATE:SHOW <DisplayState>
Indicates the gate area in the source diagram.
Suffix:
<m>
.
1..9
See "Measurement selection: MEASurement<m>" on page 522.
Parameters:
<DisplayState> ON | OFF
*RST: OFF
MEASurement<m>:GATE:ZCOupling <ZoomCoupling>
If enabled, the gate area is defined identically to the zoom area for the zoom diagram.
Suffix:
<m>
.
1..9
See "Measurement selection: MEASurement<m>" on page 522.
Parameters:
<ZoomCoupling> ON | OFF
*RST: OFF
Command Reference