User manual
Remote Control
R&S
®
RTO
571User Manual 1316.0827.02 ─ 06
MEASurement<m>:RESult:WFMCount? [<MeasType>]
MEASurement<m>:RESult:STDDev? [<MeasType>]
Returns the specified statistic result of the specified measurement type. If no parameter
is specified, the result of the main measurement is returned. The main measurement is
defined using MEASurement<m>:MAIN.
●
[:ACTual]: current measurement result
●
AVG: average of the long-term measurement results
●
EVTCount: number of measurement results in the long-term measurement
●
NPEak: negative peak value of the long-term measurement results
●
PPEak: positive peak value of the long-term measurement results
●
RMS: RMS value of the long-term measurement results
●
STDDev: standard deviation of the long-term measurement results
For a detailed description of the measurement types see chapter 5.2.1.4, "Histo-
grams", on page 138.
Suffix:
<m>
.
1..9
See "Measurement selection: MEASurement<m>" on page 522.
Query parameters:
<MeasType> Amplitude/time measurements
HIGH | LOW | AMPLitude | MAXimum | MINimum | PDELta | MEAN
| RMS | STDDev | POVershoot | NOVershoot | AREA | RTIMe |
FTIMe | PPULse | NPULse | PERiod | FREQuency | PDCYcle |
NDCYcle | CYCarea | CYCMean | CYCRms | CYCStddev |
PULCnt | DELay | PHASe | BWIDth | PSWitching | NSWitching |
PULSetrain | EDGecount | SETup | HOLD | SHR | PROBemeter
See chapter 16.2.9.3, "Amplitude/Time Measure-
ment", on page 542.
Eye/jitter measurements
ERPercent | ERDB | EHEight | EWIDth | ETOP | EBASe | QFACtor
| RMSNoise | SNRatio | DCDistortion | ERTime | EFTime | EBRate
| EAMPlitude | PPJitter | STDJitter | RMSJitter
See chapter 16.2.9.4, "Eye/Jitter Measurement", on page 550.
Spectrum measurements
CPOWer | OBWidth | SBWidth | THD
See chapter 16.2.9.5, "Spectrum", on page 552.
Histogram measurements
WCOunt | WSAMples | HSAMples | HPEak | PEAK | UPEakvalue
| LPEakvalue | HMAXimum | HMINimum | MEDian | MAXMin |
HMEan | HSTDdev | M1STddev | M2STddev | M3STddev |
MKPositive | MKNegative
See "Histogram Measurement" on page 560.
Usage:
Query only
Command Reference