User manual

Remote Control
R&S
®
RTO
564User Manual 1316.0827.02 ─ 06
MEASurement<m>:HISTogram:LCHeck<n>:LOWer:MARGin <LowerMargin>
MEASurement<m>:HISTogram:LCHeck<n>:UPPer:MARGin <UpperMargin>
Define the lower and upper margins for the limit check, respectively. Margins are not as
strict as limits and must be within the valid value range. The valid range is defined using
the MEASurement<m>:HISTogram:LCHeck<n>:VALid command.
Suffix:
<m>
.
1..9
See "Measurement selection: MEASurement<m>" on page 522.
<n> 1..18
Number of histogram measurement type, see table 16-17.
Parameters:
<Lower Margin>
<UpperMargin>
Range: -100 to 100
Increment: 10E-6
*RST: 0
16.2.9.7
Display
MEASurement<m>:DISPlay:LEVels.................................................................................564
MEASurement<m>:DISPlay:RESults................................................................................564
MEASurement<m>:DISPlay:STYLe.................................................................................565
MEASurement<m>:DISPlay:HISTogram...........................................................................565
MEASurement<m>:DISPlay:LEVels <DisplayLevels>
If enabled, the reference levels used for the measurement are displayed in the diagram.
Suffix:
<m>
.
1..9
See "Measurement selection: MEASurement<m>" on page 522.
Parameters:
<DisplayLevels> ON | OFF
*RST: OFF
MEASurement<m>:DISPlay:RESults <DisplayResult>
If enabled, the intermediate result lines required to obtain the measurement result (e.g.
signal thresholds) are displayed in the measurement diagram.
Suffix:
<m>
.
1..9
See "Measurement selection: MEASurement<m>" on page 522.
Parameters:
<DisplayResult> ON | OFF
*RST: OFF
Command Reference