User manual

Remote Control
R&S
®
RTO
556User Manual 1316.0827.02 ─ 06
LAYout:HISTogram:REMove...........................................................................................560
LAYout:HISTogram:ADD <HistogramName>, <Source>, <XStart>, <XStop>, <YStart>,
<YStop>, <Relative>, <Orientation>
Defines and displays a new histogram for the specified source.
Note: To define the mode of the histogram (vertical or horizontal), use the LAYout:
HISTogram:MODE command.
Setting parameters:
<HistogramName> String defining the histogram name which is used to refer to the
histogram by other functions.
<Source> NONE | C1W1 | C1W2 | C1W3 | C2W1 | C2W2 | C2W3 | C3W1 |
C3W2 | C3W3 | C4W1 | C4W2 | C4W3 | M1 | M2 | M3 | M4 | R1 |
R2 | R3 | R4
Data source of the histogram, see chapter 16.2.2.2, "Waveform
Parameter", on page 419
*RST: NONE
<XStart> Defines the start value of the x-value range.
<XStop> Defines the stop value of the x-value range.
<YStart> Defines the start value of the y-value range.
<YStop> Defines the stop value of the y-value range.
<Relative> ON | OFF
Defines whether relative or absolute values are used for the value
range definition.
<Orientation> VERTical | HORizontal
Usage: Setting only
SCPI confirmed
LAYout:HISTogram:SOURce <HistogramName>,<HistogramSource>
LAYout:HISTogram:SOURce? <HistogramName>
Defines the source of the histogram. Any input signal, math or reference waveform can
be selected.
Parameters:
<HistogramSource> NONE | C1W1 | C1W2 | C1W3 | C2W1 | C2W2 | C2W3 | C3W1 |
C3W2 | C3W3 | C4W1 | C4W2 | C4W3 | M1 | M2 | M3 | M4 | R1 |
R2 | R3 | R4
Waveform source of the histogram, see chapter 16.2.2.2, "Wave-
form Parameter", on page 419
*RST: NONE
Command Reference