User manual

Remote Control
R&S
®
RTO
549User Manual 1316.0827.02 ─ 06
Parameters:
<ValidRange> ILIMit | ULIMit | LLIMit | OLIMit
ILIMit
Inside (within) limit; between the upper and lower limit values
ULIMit
Upper limit; above the upper limit value
LLIMit
Lower limit; below the lower limit value
OLIMit
Outside limit; above the upper limit or below the lower limit values
*RST: ILIMit
MEASurement<m>:AMPTime:LCHeck<n>:LOWer:LIMit <LowerLimit>
MEASurement<m>:AMPTime:LCHeck<n>:UPPer:LIMit <UpperLimit>
Define the lower and upper limit for limit checking, respectiveley. The valid range is
defined using the MEASurement<m>:AMPTime:LCHeck<n>:VALid command.
Suffix:
<m>
.
1..9
See "Measurement selection: MEASurement<m>" on page 522.
<n> 1..37
Number of the amplitude/time measurement type, see 
table 16-14.
Parameters:
<UpperLimit> Range: -100 to 100
Increment: 10E-6
*RST: 0
MEASurement<m>:AMPTime:LCHeck<n>:LOWer:MARGin <LowerMargin>
MEASurement<m>:AMPTime:LCHeck<n>:UPPer:MARGin <UpperMargin>
Define the lower and upper margins for the limit check, respectively. Margins are not as
strict as limits and must be within the valid value range. The valid range is defined using
the MEASurement<m>:AMPTime:LCHeck<n>:VALid command.
Suffix:
<m>
.
1..9
See "Measurement selection: MEASurement<m>" on page 522.
<n> 1..37
Number of the amplitude/time measurement type, see 
table 16-14.
Parameters:
<UpperMargin> Range: -100 to 100
Increment: 10E-6
*RST: 0
Command Reference