User manual

Remote Control
R&S
®
RTO
543User Manual 1316.0827.02 ─ 06
Meas.
suffix
<MeasType>
parameter value
Meas. type Description/Result
19 PDCYcle Pos. duty cycle Positive duty cycle. The measurement requires at least one
complete period of a triggered signal.
20 NDCYcle Neg. duty cycle Negative duty cycle. The measurement requires at least
one complete period of a triggered signal.
21 CYCarea Cycle area Area (integral) beneath one cycle
22 CYCMean Cycle mean Mean value of one cycle
23 CYCRms Cycle RMS The RMS (Root Mean Square) value of one cycle
24 CYCStddev
Cycle σ (S-dev)
Standard deviation of one cycle
25 PULCnt Pulse count Number of positive or negative pulses of the waveform, or
both
26 DELay Delay Time difference between the any edges of two measure-
ment sources at any reference level. The measurement
result is negative if the edge of the second source comes
before the edge of the first source.
27 PHASe Phase Phase difference between two waveforms
28 BWIDth Burst width Duration of one burst, measured from the first edge to the
last
29 PSWitching Pos. switching Settling time at rising edges
30 NSWitching Neg. switching Settling time at falling edges
31 PULSetrain Pulse train Duration of N positive pulses, measured from the rising
edge of the first pulse to the falling edge of the N-th pulse.
N has to be configured.
32 EDGecount Edge count Number of positive or negative edges of the waveform, or
both
Only available for digital channels (requires MSO option
R&S RTO-B1).
33 SETup Setup time Parameters to query the setup and hold times.
Use these parameters only in queries with 
MEASurement<m>:ARES on page 570 and MEASure-
ment<n>:RESult:.. commands.
34 HOLD Hold time
35 SHT Setup/Hold time Setting parameter to enable Setup/Hold time measure-
ments.
Use this parameter only as setting with 
MEASurement<m>:MAIN on page 524 and 
MEASurement<m>:ADDitional on page 525
Command Reference