User manual

Remote Control
R&S
®
RTO
532User Manual 1316.0827.02 ─ 06
Parameters:
<HistgAveraging> ON | OFF
*RST: OFF
Usage: SCPI confirmed
REFLevel<m>:AUTO:COUNt <Weight>
Defines the number of histograms to calculate the average from if REFLevel<m>:
AUTO[:STATe] is set to ON.
This function is only available in automatic reference level mode (see REFLevel<m>:
LDETection on page 528).
Suffix:
<m>
.
2...21
Source waveform, see chapter 16.2.2.1, "Waveform Suf-
fix", on page 419.
Parameters:
<Weight> Range: 2 to 128
Increment: 2
*RST: 128
Usage: SCPI confirmed
Manual Configuration
● User Signal Level..................................................................................................532
● User Reference Level...........................................................................................534
User Signal Level
REFLevel<m>:ABSolute:HIGH........................................................................................532
REFLevel<m>:ABSolute:LOW.........................................................................................533
REFLevel<m>:ABSolute:TDIStance.................................................................................533
REFLevel<m>:ABSolute:BDIStance.................................................................................533
REFLevel<m>:ABSolute:HIGH <SignalHigh>
The signal value that represents a high level.
Suffix:
<m>
.
2...21
Source waveform, see chapter 16.2.2.1, "Waveform Suf-
fix", on page 419.
Parameters:
<SignalHigh> Range: -100E+24 to 100E+24
Increment: 1E-3
*RST: 0
Default unit: V
Command Reference