User manual

Remote Control
R&S
®
RTO
528User Manual 1316.0827.02 ─ 06
REFLevel2:LDETection MANual
REFLevel2:LMODe ABS
REFLevel2:USRLevel UREF
REFLevel2:ABSolute:LLEVel 0.001
REFLevel2:ABSolute:BDIStance 0.02
REFLevel2:ABSolute:ULEVel 0.01
REFLevel2:ABSolute:TDIStance 0.03
REFLevel2:ABSolute:MLEVel 0.005
Example: Manual reference level definition using relative values
Reference levels are set to 15%, 50%, and 85% of the high signal level for waveform
C3W1.
REFLevel8:LDETection MANual
REFLevel8:LMODe REL
REFLevel8:RELative:MODE USER
REFLevel8:RELative:LOWer 15
REFLevel8:RELative:MIDDle 50
REFLevel8:RELative:UPPer 85
Example: Automatic level detection, peak probability
Reference levels are set to the signal levels with the highest probability values for wave-
form C2W1.
REFLevel5:LDETection Auto
REFLevel5:AUTO:MODE PPRobability
General Reference Level Settings
REFLevel<m>:LDETection..............................................................................................528
REFLevel<m>:RELative:MODE.......................................................................................529
REFLevel<m>:USRLevel................................................................................................529
REFLevel<m>:LMODe...................................................................................................530
REFLevel<m>:LDETection <LevelDetection>
Defines whether the reference level is configured manually or automatically.
For automatic configuration, select the signal level to be used (see REFLevel<m>:
AUTO:MODE on page 530).
Suffix:
<m>
.
2...21
Source waveform, see chapter 16.2.2.1, "Waveform Suf-
fix", on page 419.
Command Reference