User manual

Remote Control
R&S
®
RTO
524User Manual 1316.0827.02 ─ 06
<SignalSource2> NONE | C1W1 | C1W2 | C1W3 | C2W1 | C2W2 | C2W3 | C3W1 |
C3W2 | C3W3 | C4W1 | C4W2 | C4W3 | M1 | M2 | M3 | M4 | R1 |
R2 | R3 | R4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7 | D8 | D9 | D10 |
D11 | D12 | D13 | D14 | D15
MEASurement<m>:CATegory <Category>
Defines the measurement category.
Suffix:
<m>
.
1..9
See "Measurement selection: MEASurement<m>" on page 522.
Parameters:
<Category> AMPTime | EYEJitter | SPECtrum | HIST
AMPTime
Amplitude and time measurements
EYEJitter
Eye and jitter mesurements
SPECtrum
Spectrum measurements
HIST
Histogram measurements
*RST: AMPTime
MEASurement<m>:MAIN <MeasType>
Defines or queries the main measurement. This measurement is the one referred to if
the measurement waveform is used as a source for math calculations. The main mea-
surement type must belong to the same category as the other types assigned to the same
measurement waveform, if there are any.
For details on the measurement types and categories, see chapter 5.2.1, "Measurement
Types and Results", on page 129.
Suffix:
<m>
.
1..9
See "Measurement selection: MEASurement<m>" on page 522.
Command Reference