User manual
Remote Control
R&S
®
RTO
522User Manual 1316.0827.02 ─ 06
Usage: Event
CURSor<m>:MAXimum:NEXT
Sets cursor 2 to the next smaller peak (from the current position).
Suffix:
<m>
.
1..4
Selects the cursor (set).
Usage: Event
CURSor<m>:
PEXCursion <PeakExcursion>
Defines the minimum level by which the waveform must rise or fall so that it will be iden-
tified as a maximum or a minimum by the search functions.
Suffix:
<m>
.
1..4
irrelevant
Parameters:
<PeakExcursion> Range: 0 to 100
Increment: 1
*RST: 5
Default unit: dB
16.2.9 Automatic Measurements
This chapter contains all remote commands to set up automatic measurements and to
analyze the measurement results.
Measurement selection: MEASurement<m>
With R&S RTO you can configure up to eight simultaneous measurements, and each can
include several measurement types. For manual operation, these eight measurements
are representented as tabs "Meas 1" to "Meas 8" in the "Measurements" dialog box. For
remote operation, the measurement is indicated by the suffix <m>, containing the number
of the measurement.
Only for remote operation in Tektronix emulation mode (SYSTem:LANGuage
on page 427), an additional measurement with suffix number 9 is available for Tektronix'
immediate measurements.
● General Settings...................................................................................................523
● Reference Level....................................................................................................527
● Amplitude/Time Measurement..............................................................................542
● Eye/Jitter Measurement........................................................................................550
● Spectrum...............................................................................................................552
● Histograms............................................................................................................555
● Display..................................................................................................................564
Command Reference