User manual

Remote Control
R&S
®
RTO
510User Manual 1316.0827.02 ─ 06
Parameters:
<State> ON | OFF
*RST: OFF
Usage: SCPI confirmed
WAVeform<m>:XYCurve:SWAP
Replaces the source of the x-axis with the source of the y-axis and vice versa.
Suffix:
<m>
.
1..4
XY-diagram
Usage: Event
SCPI confirmed
WAVeform<m>:XYCurve:XSOurce <XYCurveXSource>
Defines the signal source that supplies the x-values of the XY-diagram.
Suffix:
<m>
.
1..4
XY-diagram
Parameters:
<XYCurveXSource> NONE | C1W1 | C1W2 | C1W3 | C2W1 | C2W2 | C2W3 | C3W1 |
C3W2 | C3W3 | C4W1 | C4W2 | C4W3 | M1 | M2 | M3 | M4 | R1 |
R2 | R3 | R4
Source of x-values, see chapter 16.2.2.2, "Waveform Parame-
ter", on page 419
*RST: NONE
Usage: SCPI confirmed
WAVeform<m>:XYCurve:YSOurce <XYCurveYSource>
Defines the signal source that supplies the y-values of the XY-diagram.
Suffix:
<m>
.
1..4
XY-diagram
Parameters:
<XYCurveYSource> NONE | C1W1 | C1W2 | C1W3 | C2W1 | C2W2 | C2W3 | C3W1 |
C3W2 | C3W3 | C4W1 | C4W2 | C4W3 | M1 | M2 | M3 | M4 | R1 |
R2 | R3 | R4
Source of y-values, see chapter 16.2.2.2, "Waveform Parame-
ter", on page 419
*RST: NONE
Command Reference