User manual

Remote Control
R&S
®
RTO
503User Manual 1316.0827.02 ─ 06
<YStop> Defines the y-value at the end of the zoom area.
<ZoomName> Defines the name of the new zoom diagram.
Usage: Setting only
SCPI confirmed
LAYout:ZOOM:ADDCoupled <ZoomName>, <XOffset>, <YOffset>,
<NewZoomName>
Creates a new zoom diagram based on the settings of an existing zoom area for the same
source.
Parameters:
<NewZoomName> Defines the name of the new zoom diagram.
Setting parameters:
<ZoomName> Defines the name of the zoom diagram to be copied.
<XOffset> Defines an offset to the existing zoom area in x direction.
<YOffset> Defines an offset to the existing zoom area in y direction.
Usage: SCPI confirmed
LAYout:ZOOM:HORZ:MODE <DiagramName>, <ZoomName>,<Mode>
LAYout:ZOOM:HORZ:MODE? <DiagramName>, <ZoomName>
Defines whether absolute or relative values are used to specify the x-axis values. Since
the zoom area refers to the active signal, relative values ensure that the zoom area
remains the same.
Parameters:
<Mode> ABS | REL
Mode used to specify the x-axis values of the zoom area.
*RST: ABS
Parameters for setting and query:
<DiagramName> Name of the diagram on which the zoom area is based.
<ZoomName> Name of the zoom diagram
LAYout:ZOOM:HORZ:ABSolute:POSition <DiagramName>,
<ZoomName>,<Position>
LAYout:ZOOM:HORZ:ABSolute:POSition? <DiagramName>, <ZoomName>
Defines the x-value of the centerpoint of the zoom area.
Parameters:
<Position> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0.01
Command Reference