User manual

Remote Control

R&S

RTO

500User Manual 1316.0827.02 ─ 06

<ParentType> NONE | HORizontal | VERTical | TAB

Position of the new diagram in relation to the existing one.

HORizontal

Besides the existing diagram

VERTical

Above or below the existing diagram

TAB

In a new tab in the existing diagram

<InsertBefore> ON | OFF

If on, the new diagram is inserted to the left (for HORizontal),

above (for VERTical) or in a tab before the existing one.

<FirstSource> NONE | C1W1 | C1W2 | C1W3 | C2W1 | C2W2 | C2W3 | C3W1 |

C3W2 | C3W3 | C4W1 | C4W2 | C4W3 | M1 | M2 | M3 | M4 | R1 |

R2 | R3 | R4 | XY1 | XY2 | XY3 | XY4 | MRESult1 | MRESult2 |

D3 | D4 | D5 | D6 | D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 |

D15 | MSOB1 | MSOB2 | MSOB3 | MSOB4

Waveform to be diplayed in the new diagram, see chap-

ter 16.2.2.2, "Waveform Parameter", on page 419.

<DiagramName> Name of the new diagram.

Usage: Setting only

SCPI confirmed

LAYout:REMove <sNodeName>

Setting parameters:

Usage: Setting only

SCPI confirmed

LAYout:SHOW <sNodeName>

Setting parameters:

Usage: Setting only

SCPI confirmed

LAYout:SIGNal:ASSign <DiagramName>, <Source>

Shows the specified waveform in the selected diagram.

Command Reference