User manual

Remote Control
R&S
®
RTO
497User Manual 1316.0827.02 ─ 06
DISPlay:DIAGram:GRID <Show>
If enabled, a grid is displayed in the diagram area.
Parameters:
<Show> ON | OFF
*RST: ON
DISPlay:DIAGram:CROSshair <Crosshair>
If selected, a crosshair is displayed in the diagram area. A crosshair allows you to select
a specific data point by its co-ordinates.
Parameters:
<Crosshair> ON | OFF
*RST: ON
DISPlay:DIAGram:LABels <ShowLabels>
If enabled, labels mark values on the x- and y-axes in specified intervals in the diagram.
Parameters:
<ShowLabels> ON | OFF
*RST: ON
DISPlay:DIAGram:TITLe <DiagTitleState>
If enabled, the tab titles of all diagrams are displayed: "Diagram1", "Diagram2" ...
If disabled, the tab titles are not shown except for those in a tabbed diagram. In tabbed
diagrams, the tab titles are required to change the tabs.
Parameters:
<DiagTitleState> ON | OFF
*RST: ON
DISPlay:DIAGram:YFIXed <YGridFixed>
If enabled, the horizontal grid lines remain in their position when the position of the curve
is changed. Only the values at the grid lines are adapted. This reflects the behavior of
traditional oscilloscopes.
Parameters:
<YGridFixed> ON | OFF
*RST: ON
DISPlay:SIGBar[:STATe] <State>
If enabled, the signal bar is displayed in the diagram area.
Command Reference