User manual

Remote Control
R&S
®
RTO
494User Manual 1316.0827.02 ─ 06
DISPlay:COLor:SIGNal<m>:ASSign <ColorTable>
Assigns the color table to the specified signal.
Suffix:
<m>
.
1..59
Waveform number, see chapter 16.2.2.1, "Waveform Suf-
fix", on page 419.
Parameters:
<ColorTable> Color table name to be assigned to the signal.
DISPlay:COLor:SIGNal<m>:USE <UseColorTable>
If enabled, the selected waveform is displayed according to its assigned color table.
If this option is disabled, the default color table is used, i.e. the intensity of the specific
signal color varies according to the cumulative occurance of the values.
Suffix:
<m>
.
1..59
Waveform number, see chapter 16.2.2.1, "Waveform Suf-
fix", on page 419.
Parameters:
<UseColorTable> ON | OFF
*RST: OFF
16.2.7.2 Color Tables
DISPlay:COLor:PALette:ADD..........................................................................................494
DISPlay:COLor:PALette:REMove....................................................................................494
DISPlay:COLor:PALette:COUNt......................................................................................495
DISPlay:COLor:PALette:POINt:ADD................................................................................495
DISPlay:COLor:PALette:POINt:INSert..............................................................................495
DISPlay:COLor:PALette:POINt:REMove...........................................................................495
DISPlay:COLor:PALette:POINt[:VALue]............................................................................495
DISPlay:COLor:PALette:POINt:COUNt.............................................................................496
DISPlay:COLor:PALette:ADD <Name>
Adds a new color table with the specified name.
Setting parameters:
<Name> color table
Usage: Setting only
DISPlay:COLor:PALette:REMove <Name>
Removes the specified color table.
Command Reference