User manual

Remote Control
R&S
®
RTO
493User Manual 1316.0827.02 ─ 06
Parameters:
<State> ON | OFF
*RST: OFF
DISPlay:PERSistence:TIME <Time>
If persistence is enabled (DISPlay:PERSistence[:STATe]), each new data point in
the diagram area remains on the screen for the duration defined here.
Parameters:
<Time> Range: 0.05 to 50
Increment: 0.05
*RST: 0.05
Default unit: s
DISPlay:
PERSistence:RESet
Resets the display, removing persistent values.
Usage:
Event
DISPlay:INTensity <Intensity>
This value determines the strength of the waveform line in the diagram. Enter a percent-
age between 0 (not visible) and 100% (very strong).
The exact mapping of the cumulative value occurences according to the assigned color
table is guaranteed only if the intensity is set to 50% (default). All other intensity values
falsify the mapping but may improve the visibility of the signal.
See also: chapter 4.1.2.1, "Editing Waveform Colors", on page 89.
Parameters:
<Intensity> Range: 0 to 100
Increment: 1
*RST: 50
Default unit: %
DISPlay:DIAGram:STYLe <Style>
Select the style in which the waveform is displayed.
Parameters:
<Style> VECTors | DOTS
VECTors
The individual data points are connected by a line.
DOTS
Only the individual data points are displayed.
*RST: VECTors
Command Reference