User manual

Remote Control
R&S
®
RTO
477User Manual 1316.0827.02 ─ 06
Parameters:
<Width> Range: 100E-12 to 10000
Increment: 100E-9
*RST: 5E-9
Default unit: s
TRIGger<m>:PATTern:WIDTh:DELTa <WidthDelta>
Defines a range around the width value specified using TRIGger<m>:PATTern:
WIDTh[:WIDTh].
Suffix:
<m>
.
1..3
1 = A-event only
Parameters:
<WidthDelta> Range: 0 to 432
Increment: 500E-12
*RST: 0
Default unit: s
Serial Pattern Trigger
The slew serial pattern trigger is only available for the A-event (Suffix = 1).
TRIGger<m>:SPATtern:CSOurce[:VALue]........................................................................477
TRIGger<m>:SPATtern:CSOurce:EDGE..........................................................................477
TRIGger<m>:SPATtern:CSOurce:LEVel...........................................................................478
TRIGger<m>:SPATtern:PATTern.....................................................................................478
TRIGger<m>:SPATtern:CSOurce[:VALue] <ClockSource>
Defines the source of the clock signal.
Suffix:
<m>
.
1..3
Indicates the event in a trigger sequence: 1 = A-event, 2 = B-event,
3 = R-event.
Parameters:
<ClockSource> CHANnel1 | CHANnel2 | CHANnel3 | CHANnel4
Input channel
*RST: CHANnel1
TRIGger<m>:SPATtern:CSOurce:EDGE <ClockEdge>
Together with the clock level (see TRIGger<m>:SPATtern:CSOurce:LEVel
on page 478), the clock edge defines the point in time when the state of the data signal
is checked.
Command Reference