User manual

Remote Control
R&S
®
RTO
473User Manual 1316.0827.02 ─ 06
Parameters:
<TimeDelta> Range: 0 to 10
Increment: 100E-9
*RST: 0
Default unit: s
Data2Clock Trigger
The Data2Clock trigger is only available for the A-event (Suffix = 1).
TRIGger<m>:DATatoclock:CSOurce[:VALue]...................................................................473
TRIGger<m>:DATatoclock:CSOurce:EDGE......................................................................473
TRIGger<m>:DATatoclock:CSOurce:LEVel......................................................................473
TRIGger<m>:DATatoclock:HTIMe...................................................................................474
TRIGger<m>:DATatoclock:STIMe....................................................................................474
TRIGger<m>:DATatoclock:CSOurce[:VALue] <ClockSource>
Selects the source of the clock signal.
Suffix:
<m>
.
1..3
Indicates the event in a trigger sequence: 1 = A-event, 2 = B-event,
3 = R-event.
Parameters:
<ClockSource> CHANnel1 | CHANnel2 | CHANnel3 | CHANnel4
Input channel
*RST: CHANnel1
TRIGger<m>:DATatoclock:CSOurce:EDGE <ClockEdge>
Sets the edge of the clock signal to define the time reference point for the setup and hold
time.
Suffix:
<m>
.
1..3
1 = A-event only
Parameters:
<ClockEdge> POSitive | NEGative | EITHer
See chapter 16.2.2.3, "Slope Parameter", on page 420.
*RST: POSitive
TRIGger<m>:DATatoclock:CSOurce:LEVel <ClockLevel>
Sets the voltage level for the clock signal. Both this command and TRIGger<m>:
DATatoclock:CSOurce:EDGE define the starting point for calculation of the setup and
hold time.
Command Reference