User manual

Remote Control
R&S
®
RTO
470User Manual 1316.0827.02 ─ 06
Suffix:
<m>
.
1..3
Indicates the event in a trigger sequence: 1 = A-event, 2 = B-event,
3 = R-event.
Parameters:
<Width> Range: 100E-12 to 10000
Increment: 100E-9
*RST: 5E-9
Default unit: s
TRIGger<m>:
INTerval:DELTa <WidthDelta>
Defines a range around the "Interval width" value specified using TRIGger<m>:
INTerval:WIDTh on page 469.
Suffix:
<m>
.
1..3
Indicates the event in a trigger sequence: 1 = A-event, 2 = B-event,
3 = R-event.
Parameters:
<WidthDelta> Range: 0 to 10
Increment: 100E-9
*RST: 0
Default unit: s
Slew Rate Trigger
The slew rate trigger is not available for the B-event (Suffix = 2).
TRIGger<m>:SLEW:SLOPe............................................................................................470
TRIGger<m>:LEVel<n>:SLEW:UPPer..............................................................................471
TRIGger<m>:LEVel<n>:SLEW:LOWer.............................................................................471
TRIGger<m>:SLEW:RANGe...........................................................................................471
TRIGger<m>:SLEW:RATE..............................................................................................472
TRIGger<m>:SLEW:DELTa............................................................................................472
TRIGger<m>:SLEW:SLOPe <Slope>
Selects the edge type for the trigger event.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event, 3 = R-event.
Parameters:
<Slope> POSitive | NEGative | EITHer
See chapter 16.2.2.3, "Slope Parameter", on page 420.
*RST: POSitive
Command Reference